Nitrate Ion-Selective Electrode (NO3-BTA) Specifications and User Guide TROUBLESHOOTING -Primary Test: Check the raw voltages while calibrating in the standards. The high (100 mg/L) should be around 1.6 volts. The......
Tech Support Search
Chloride Ion-Selective Electrode (CL-BTA) Specifications and User Guide TROUBLESHOOTING -Primary Test: Check the raw voltages while calibrating in the standards. The high (1000 mg/L) should be around 2.0 volts. The......
ORP Sensor (ORP-BTA) Specifications and User Guide TROUBLESHOOTING -Primary Test: The ORP Sensor consists of an ORP Electrode connected to an Electrode Amplifier using a BNC connector. Connect the Electrode......
...filter used in hospitals by respiratory technicians. This filter is used with the Go Direct® Spirometer (GDX-SPR) and the Spirometer (SPR-BTA) The PDF below is the specifications sheet released by......
The discussion below is based on tests done with a new-style MG-BTA with a rotating head in August 2006. The whole issue of accuracy is pretty difficult to address. There......
This article refers to the following sensors: Dual-Range Force Sensor (DFS-BTA) Go Direct® Force and Acceleration Sensor (GDX-FOR) Go Direct® Sensor Cart (GDX-CART-G) Go Direct® Sensor Cart (GDX-CART-Y) Wireless Dynamics......
The BTA version of the CO2 Gas Sensor is not supported by the original Go!Link. (The original Go!Link label simply says Go!Link, like the one shown below, while newer versions......
Yes, Vernier does sell a Goniometer. Goniometer (GNM-BTA) However, if you already have our Low-g Accelerometer, you can use it to report tilt angle using our Logger Pro 3 software.......
If a Current Probe (DCP-BTA) was subjected to more than 0.6A, it will burn out a resistor inside the sensor. This can happen when students don’t get the value they......
This article refers to the following products: Dual-Range Force Sensor (DFS-BTA) Go Direct® Force and Acceleration Sensor (GDX-FOR) Wireless Dynamics Sensor System (WDSS) All three of these sensors have a......