The Vernier-branded can not ID on in Logger Pro when used with a LabPro interface because the LabPro firmware was created before this sensor. There......
Affects Logger Pro and LabPro. If you turn off the default zero at collect option for the rotary motion sensor, and then zero the sensor......
Note that the is no longer available, and has been replaced by the combination of: and The Dual Channel Amplifier (the box part of the......
The data shown in the file below were collected with the Vernier GPS at rest. The points apparently show scatter, but if you look at......
No. The will only fit onto Vernier Dynamics Carts. The Vernier Cart Picket Fence is not long enough to fit into the slots on a......
Heat pulsers are an item that we do not advertise because we only recommend them for use with the RTP or TST Heat & Temp......
Here are two common ways to collect data from a rocket launch: 1. For air rockets, the simplest setup to measure the launch velocity is......
Between 8/27/08 and 9/5/08, a small number of power supplies were shipped that were defective. If you received a power supply around this time with......
1. Make sure that your Dell Mini 9 has been updated with the latest software from dell by executing the Update Manager available under System......
All Vernier EKG sensors have proper isolation. The electrode inputs are isolated from the power supply for the sensor....