Yes. If you use the , the ME-9259A will work with LabPro....
Yes, older non auto-ID sensors can work with EasyData. To use the older sensors you have to load special EasyData AppVar file(s) onto your calculator,......
(this TIL is about older software, and does not apply to Logger Pro.) Several people have asked about how they can create their own challenge......
The spacing of the grid lines in Logger Pro are automatically determined based on the axes limits in the graph. You can adjust the axes......
The Vernier-branded can not ID on in Logger Pro when used with a LabPro interface because the LabPro firmware was created before this sensor. There......
Affects Logger Pro and LabPro. If you turn off the default zero at collect option for the rotary motion sensor, and then zero the sensor......
Note that the is no longer available, and has been replaced by the combination of: and The Dual Channel Amplifier (the box part of the......
The data shown in the file below were collected with the Vernier GPS at rest. The points apparently show scatter, but if you look at......
No. The will only fit onto Vernier Dynamics Carts. The Vernier Cart Picket Fence is not long enough to fit into the slots on a......
Heat pulsers are an item that we do not advertise because we only recommend them for use with the RTP or TST Heat & Temp......