You can install magnets in the so that dynamics carts elastically bounce off the End Stop at low speeds. But the magnets must be installed......
To manually set up a nonauto-ID sensor in DataMate perform the following steps: 1) Connect the sensor to channel CH 1 on the LabPro or......
Recent versions of Logger Pro (3.5 and newer) allow a dynamic numeric range of 1.1e-99 to 1e99. Older versions have more limited range. If a......
The current sensor function of the can be used at the same time as the analog out function of LabPro, but the procedure is not......
None of the Vernier interfaces, e.g. LabPro, will connect directly to the Fourier MultiLog. In order to collect data with the MultiLog and Vernier sensors,......
There are circumstances in Logger Pro or Logger Lite for OS X where the toolbar can disappear. In almost all cases, you have clicked the......
The nut is a 1/4-20....
Two WDSS sensors will only be approximately in sync, and the sync will vary from trial to trial due to jitter in the computer communications......
All orders from Puerto Rico are processed through our main office in Beaverton, OR. For more info see: https://www.vernier.com/how-to-order/...
LabQuest Mini gets its power through the computer’s USB port. There are rare cases in which there is a limit to how much power is......